OMNITRONIX OMNI-11KW-SW

GENERAL DESCRIPTION

OMNI-11KW-SW Solid State SW Broadcast Transmitter, 11,000 Watt

Tropical Band Short Wave

The only Solid State Tropical Band Transmitter in the Industry
Exceptional Efficiency
High Reliability
One Year Limited Warranty

The OMNI-11KW-SW is the 11,000 watt member of the Omnitronix series of competitively priced, highly efficient AM Short Wave Transmitters. This 100% solid state transmitter uses proven pulse duration modulation (PDM) technology to provide highly efficient broadcast operation. Enhanced reliability has been built into the OMNI-11KW-SW through the use of redundant modulator and power amplifier circuitry, extensive antenna and power-mains transient protection and the use of stainless steel hardware and Teflon insulated wire throughout the transmitter chassis. Troubleshooting has been made easy through the use of meters and numerous LED status and alarm indicators. The advanced modular design allows front-panel access to all plug-in power amplifier and control modules. This, in addition to true "hot-swap" capability, provides for quick and easy maintenance which virtually eliminates off-the-air situations. The superior reliability, rugged design, highly efficient AC to RF conversion, and ease of maintenance makes the OMNI-11KW-SW the most cost effective solid state AM short wave transmitter available. The OMNI-11KW-SW solid state transmitter meets the specifications of various international broadcasting authorities.

TECHNICAL SPECIFICATIONS
Transmitter type	100% solid state AM short wave
Power output	11,000 W (adjustable 10% - 100% of rated output)
RF frequency range	3 - 7 MHz
Type of modulation	Digital PDM
Power cutback	5 field adjustable settings
Frequency stability	±5 ppm (±8 Hz maximum)
Modulation capability	100% positive peak at 100% of rated output
Audio frequency response	+1, -2 dB, 50 Hz to 7 kHz
Audio harmonic distortion	<4%, 50 Hz to 7 kHz
Carrier shift	<3% at 100% of rated output, 95% modulation
Spurious & harmonic energy	Exceeds FCC requirements
Power input	220 VAC ±15%, 50/60 Hz (custom voltages available)
Power supply variation	10% voltage variation, 48-63 Hz frequency variation
Transient protection	Isolation transformer & surge suppressors
Overall efficiency	>60%
RF load	50 ohms unbalanced
Noise & hum	<50 dB below 100% modulation at 100% of rated output
Duty cycle	Continuous 100% modulated sine wave
Audio input	±10 dBm, 600 ohms
Remote control	All controls have optically isolated inputs Power cutback levels 1 - 5 Alarm reset Transmitter on/off
Remote monitor	Power cutback status Voltages and current 16 status alarms
Metering	Voltage and current Power cutback status
Electronic protection	Over-voltage: +20% with automatic recycle Under-voltage: -40% automatic standby Over-heating: automatic standby of individual power amps High VSWR: >1.2:1, 3 attempts before standby Output protection: gas tube on transmission line and band-pass harmonic filter
Environmental & mechanical	Temp: 0 - 40° Celsius Cooling: low-velocity air Altitude: 0 - 3,000 m (10,000 ft) Width: 112 cm (44 inches) Height: 188 cm (74 inches) Depth: 76 cm (30 inches) Weight: 545 kg (1,200 lbs)
Warranty	One year limited warranty
Specifications may change without notice

TUBE COMPLEMENT
RF stages		AF stages and modulator
Number	Type	Number	Type
-	-	-	-

THIS TYPE OF TRANSMITTER IS INSTALLED IN THE FOLLOWING COUNTRIES
	ITU	Country	ITU	Country
	B	BRAZIL